IDirect3DVolumeTexture9::SetLOD Method

Sets the most detailed level of detail (LOD) for a managed texture.

Syntax

DWORD SetLOD(      

    DWORD LODNew
);

Parameters

LODNew
[in] Most detailed LOD value to set for the mipmap chain.

Return Value

A DWORD value, clamped to the maximum LOD value (one less than the total number of levels). Subsequent calls to this method will return the clamped value, not the LOD value that was previously set.

Remarks

This method applies to the following interfaces, which inherit from IDirect3DBaseTexture9.
IDirect3DCubeTexture9
IDirect3DTexture9
IDirect3DVolumeTexture9
IDirect3DResource9
IDirect3DVolumeTexture9::SetLOD is used for LOD control of managed textures. This method returns 0 on nonmanaged textures.
IDirect3DVolumeTexture9::SetLOD communicates to the Microsoft?Direct3D?texture manager the most detailed mipmap in the chain that should be loaded into local video memory. For example, in a five-level mipmap chain, setting LODNew to 2 indicates that the texture manager should load only mipmap levels 2 through 4 into local video memory at any given time.
More specifically, if the texture was created with the dimensions of 256?56, setting the most detailed level to 0 indicates that 256?56 is the largest mipmap available, setting the most detailed level to 1 indicates that 128?28 is the largest mipmap available, and so on, up to the most detailed mip level (the smallest texture size) for the chain.